KARBONISASI LIMBAH PELEPAH KELAPA SAWIT SEBAGAI ADSORBEN UNTUK MENGURANGI KADAR Fe (III) PADA AIR GAMBUT
No Thumbnail Available
Date
2020-10
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
Abstract
Oil palm fronds are waste generated from oil palm plantations from pre to post harvest.
These palm fronds have not been used optimally, they are usually burned or used as
fertilizer. Palm fronds contain high cellulose and make the oil palm fronds potentialy as
adsorbent. Shynthesis of COPF (Charcoal oil palm fronds) use carbonization method.
COPF shynthesis process begin with collecting the palm fronds waste, then drying
under sunlight continuous in oven for 2 hours. Next step homogenity size particle by
sieving with unit 80 mesh and 120 mesh followed by carbonization, carbonization
temperature 600 0C for 60 minutes. Moisture and ash content were determined with
gravimetry, also applied in adsorption Fe (III) in peat water with contact time, mass
adsorben and volume of peat water variations. Moisture value of adsorbent is 2,392%
and the ash content 9,958%. Both of them qualify the technical activated charcoal
requirements according SNI 06-3730-1995. The best result of adsorption Fe (III) in peat
water show in contact time was 30 minutes, mass adsorben was 1 g and volume of peat
water was 100 mL. The higher adsorption efficiency is 96,13% and capacity 0,052 mgg-
1. COPF is effectively used in reducing Fe (III) levels in peat water as evidence by its
high adsorption effciency.
Description
Keywords
charcoal, oil palm fronds, peat water