UR - Student Paper Degree

Permanent URI for this community

https://repository.unri.ac.id/handle/123456789/26

Browse

Browsing UR - Student Paper Degree by Author "A Yelmida"

Now showing 1 - 4 of 4
  • No Thumbnail Available
    Item
    INHIBITOR KOROSI PADA AIR LAUT MENGGUNAKAN EKSTRAK TANIN DARI DAUN GAMBIR DENGAN PELARUT ETANOL-AIR
    (2013-01-28) Regina, Nikita; Irianty Rozanna Sri; A Yelmida
    Corrosion is a destructive process or decreases of metal quality because of the reaction with corrosive environment. One of the methods that able to decrease corrosion rate is by the addition of an inhibitors into corrosive media. Tannin is a component that can be extracted from natural material to be used as an inhibitor. Gambier leaves is one of natural materials which contains of tannin. The purpose of this research is to get the best concentration of inhibitor and inhibition efficiency from extracted gambier leaves by varying the contact time and pH of corrosive media in decreasing corrosion rate. This research was done by extracting tannin from gambier leaves with soxhletation method by using ethanol-water solvent with comparison 1:4 and then evaporated to get the condensed extract of gambir leaves. The research parameters is concentrations of inhibitor(1000, 3000, and 5000) ppm, contact time variation (5, 10, 15, 20) days, and pH (3,6,9) of sea water. Examination is conducted with gravimetric method to calculate weight loss of metal. The result of this research : the best concentration of inhibitor is 5000 ppm, contact time is 20 days and the lowest corrosion rate is 0,000507 gr/cm2 per day with inhibition efficiency is 60,345% and pH inhibitor variation from extracted gambier leaves is effective in decreasing corrosion rate at pH ±9 of sea water and contact time 20 days with the lowest corrosion rate are 0,000853 gr/cm² per day at concentration 1000 ppm, 0,000590 gr/cm².day at concentration 3000 ppm, and 0,000372 gr/cm².day at concentration 5000 ppm.
  • No Thumbnail Available
    Item
    INHIBITOR KOROSI PADA AIR LAUT MENGGUNAKAN EKSTRAK TANIN DARI DAUN GAMBIR DENGAN PELARUT METANOL-AIR
    (2013-01-28) Ilandita, Rima; Irianty Rozanna Sri; A Yelmida
    Corrosion is a destructive process or degradation of metal quality because reaction with corrosive environment. Addition of inhibitors into corrosive media is one of the methods that able to decrease corrosion rate. Leaves of gambier is one of natural material which contains of tannin that able to be used as an inhibitor to protect metal from corrosion. The purpose of this research is to get the best concentration of inhibitor and inhibition efficiency of tannin extract from gambier leaves by varying the contact time and pH of corrosive media in decreasing corrosion rate. Tannin extract from leaves of gambier is obtained with soxhletation method by using methanol-water solvent with comparison 1:4 and then evaporated to get condensed extract of gambier leaves. Concentrations of tannin inhibitor that used are 1000, 3000, and 5000 ppm, with contact time variation are 5, 10, 15, 20 days, and variation pH of sea water as corrosive media are 3, 6, 9. Examination is conducted with gravimetry method to calculate weight loss of metal. The result of this research showed that lowest corrosion rate is 0,000547 gr/cm2.day at concentration of inhibitor 5000 ppm and contact time 20 days with average inhibition efficiency is 51,78%. At variation pH of sea water are obtained that lowest corrosion rate at pH of sea water ±9 is 0,000503 gr/cm2.day.
  • No Thumbnail Available
    Item
    Pelarutan Minyak Beku Pada Sumur Produksi Dengan Campuran Pelarut Organik
    (2013-06-27) Maulirany, Nancy; Bahruddin; A Yelmida
    Precipitation caused by the high content of paraffin and asphaltene in crude oil can be deposited in the wellbore and/or production pipe. Deposit was called the frozen oil. In this research will be observed the influence of temperature, solvent mixture and soaking time on the solubility of paraffin and asphaltene in crude oil and hydrocarbon composition and determine the fraction of SARA (saturate, aromatic, resin and asphaltene) in the filtrate of solubility test results. Solvent mixtures used in this study there are four (4) groups: solvent A (xylen + diesel fuel), solvent B (toluene + diesel fuel), solvent C (xylen + diesel fuel + alkylbenzene sulfonate) and solvent D (toluene + diesel fuel + alkylbenzene sulfonate), with temperature 60 and 90 0C and soaking time 5, 10, 20 and 30 minutes. % Solubility shows that the solvent C at a temperature of 90 0C and 30 minutes soaking time has the greatest solubility is 92%. Even though the solubility of the solvent C is the highest, but the addition of alkylbenzene sulfonate in solvents C are not enough increases the solubility compared to the solvent A without alkylbenzene sulfonate. From the analysis of Gas Chromatography (GC) at filtrate and original frozen oil showed that the original frozen oil C29 frozen oil has the highest concentration of 12.04%, while in the filtrate C29 is no longer high, soluble fractions into lighter ones. From the analysis of the concentration of saturate, aromatic, resin and asphaltene (SARA) at filtrate and original frozen oil, indicating that the initial sample asphaltene frozen oil have the highest concentration of 36.17%, while the concentration asphaltene in the filtrate no longer high.
  • No Thumbnail Available
    Item
    PROSES BLEACHING PELEPAH SAWIT HASIL HIDROLISIS SEBAGAI BAHAN BAKU NITROSELULOSA DENGAN VARIASI SUHU DAN WAKTU REAKSI
    (2013-03-21) Irfanto, Herryawan; Padil; A Yelmida
    One way to improve the composition of cellulose in hydrolysis product of oil palm fronds is using bleaching process. The purpose of this research is to find out the temperature and time of bleaching that can give the composition of cellulose above 92%. The method that used is bleaching using hydrogen peroxide with variation of temperature of bleaching (50, 60, 70, 80, and 90oC) and time of bleaching (30, 45, 60, 75, and 90 minutes). After bleaching, the chemical composition of bleaching product of oil palm fronds is analyzed. The best operation condition is be able at temperature of bleaching 90oC and time of bleaching 60 minutes with the purity of alpha-cellulose obtained 95,11%.